Flux Easy Coat (Cold Applied Bitumen Emulsion) 140KG

Description Flux Easy Coat Non fib rated bitumen emulsion coating of brushing consistency which dries to give a firm, flexible, joint less waterproof and protective membrane. Flux Easy Coat is suitable for the treatment of concrete, asphalt, metal, roofing felt and other similar roofing surfaces whether flat, sloping or vertical. Where added protection is required on roofs, and may be used in conjunction with a reinforcing fabric. Consistency, suitable for new and old concrete. Many areas of use, versatile. Advantage General waterproofing and damp proofing of concrete, asbestos cement sheets, roofing felts, wood, Protection of steelwork, pipes and metal. Vapour Permeable allows substrate to breathe. Reduced chloride penetration due to hard impermeable surfaces. Simple and easy to use, no skilled labour required. Single component,use as supplied. Solvent free. Cold applied, no heating required. Non-slumping. Easy application due to pintable Application Procedure Surface Preparation: Surfaces to which Flux Easy Coat is to be applied must be clean and free of dirt, dust, rust or any other material which may impair adhesion. Where moss or lichen is present, remove sheets. Cut and reseal blisters in asphalt or roofing. Remove chippings other than those that form the surface of mineralized felt. Porous surfaces such as concrete and fiber reinforced cement should be primed using. Flux Easy Coat diluted with clean water. Old concrete and steel must be structurally sound prior to application. Application: Apply by brush or roller. Two or more coats must be applied to ensure a durable finish. Second and subsequent coats should be applied at right angles to each other once previous coats have fully dried. Flux Easy Coat may be applied to damp but not wet surfaces, dampen brushes before and occasionally during use to avoid clogging and ease application. During hot, dry weather application may be assisted by dampening the surfaces to be treated.